トピック: call_profiles (言語: default) |
Using the ISDN Dial-Out Profiles dialog, you can create and manage call profiles featuring different phone numbers.
The profiles thus created are used in the Messaging dialog to send notifications via ISDN Call Action (CL).
Note: | This feature is not available for Basic cameras. |
---|
Test Profiles | Select a previously created profile in order to check your entries. | ||||||||
---|---|---|---|---|---|---|---|---|---|
Profile name | Enter a unique profile name. | ||||||||
Remove | To delete a stored profile, click on Delete and confirm your selection by clicking on the Set button. | ||||||||
Phone Number |
Enter the phone number for the camera to call. You can enter multiple phone numbers. The camera then calls the numbers one by one until one of them accepts the call. |
||||||||
Dial Retries |
Defines the maximum number of dial retries. Value range: 1 .. 10. |
||||||||
Dial Timeout |
Defines the dial timeout between two retries while dialing in seconds. |
||||||||
Message name | Select one of the voice messages recorded in the Manage Voice Messages dialog. | ||||||||
After the message has been sent |
|
||||||||
Hangup after |
Set the maximum connection time for a voice message. Value range: 1 .. 10 minutes |
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.