トピック: system-update (言語: default) |
Open the Upload Camera Software dialog to select special files with a .mpl
file extension for updating the camera software.
Warning! |
|
---|
To update the camera software do the following:
Note: |
After the software has been updated successfully and after you have rebooted the camera, message windows may alert you of configuration parameters not matching. If this is the case, you should reset the configuration to factory defaults, either in parts or as a whole. If you would like to keep certain settings, you should choose Everything except the parts checked below and then activate all options that will not be replaced, such as Security, Networking, Audio, ...). This applies to the Audio section in particular, if the camera is being administered using an ISDN connection. You will not be able to reach the camera otherwise! For additional information on this topic, see the Configuring the Camera online help topic. |
---|
Open the Verify Camera Software dialog if you would like to check if the camera software matches a specific upload file.
Note: | Reboot the camera after the verification has finished. |
---|