トピック: Event filter |
Starting with software version V1.9.4, the MOBOTIX camera has been equipped with event filters. They allow you to restrict actions and messages or event stories including pre- and post-alarm images to selected events only.
Note: | The factory default setting for all filters is All, meaning that the respective functions (event stories, actions and messages) are performed for all events. |
---|
Event Story (Pre and Post-alarm Images)
Open the General Event Settings dialog to select certain events in the Event Story section. An event story (the images before and after the event) is saved only when one of the selected events occurs.
Note: | The event image of a detected event is always stored. |
---|
Messaging
Open the Messaging dialog to select certain events in the Event Selection section. When one of the selected events occurs, the camera sends a message.
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.