トピック: Configuring, LEDs |
The camera uses the six LEDs on its front to inform you about different actions/states of the system. Open the LED Setup dialog to modify LED behavior or to deactivate them entirely.
The camera keys on the camera's front (R, L) are labeled as as seen by the camera, the LEDs are identified by looking at the camera itself (12 to 10 o'clock positions):
Right side of camera (as seen by the camera) |
Left side of camera (as seen by the camera) |
Parameters | Description | ||||||
---|---|---|---|---|---|---|---|
LED main switch |
The main switch activates or deactivates all LEDs of the camera.
|
||||||
Set all LEDs |
You can assign the same function to all LEDs:
All other options correspond to the functions that you can select for the individual LEDs. For more detailed information, see the LED Signals help topic.
|
You can assign a different signaling function to every LED:
Signal | Meaning | ||
---|---|---|---|
Off |
The LED's signal feature is deactivated during regular operation.
|
||
On | The LED is on without interruption. | ||
Blink | The LED blinks slowly. | ||
Flicker | The LED blinks rapidly. | ||
Event | The LED indicates every triggered event. | ||
PIR | The LED indicates when an event has been triggered by the passive infrared detector. | ||
Left key | The LED goes on when you press the L key on the camera's front. | ||
Right key | The LED goes on when you press the R key on the camera's front. | ||
Signal input | The LED goes on when the signal input is active. | ||
Signal output: | The LED goes on when the signal output is active. | ||
Microphone | The LED indicates when an event has been triggered by the microphone. | ||
IR remote control | The LED indicates when an infrared signal by a remote control has been received. |
PIR Threshold |
Define the trigger level for the passive infrared detector.
|
||||||
---|---|---|---|---|---|---|---|
Signal output |
|
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.